Test4actual – Leading the way in Studying IT Certifications

Here are some practice about F5 Networks F50-521 exam which are released by Test4actual,it provides a lot of IT certification exams,I hope they will help you pass your test.
Any doubts about the products quality left? Try the Test4actual F5 Networks F50-521 exam free demo before buy!

1:Where is the load-balancing mode specified?
A.within the pool definition
B.within the node definition
C.within the virtual server definition
D.within the pool member definition
Answer:A

2:Which three methods can be used for initial access to a BIG-IP system? (Choose three.)
A.CLI access to the serial console port
B.SSH access to the management port
C.SSH access to any of the switch ports
D.HTTP access to the management port
E.HTTP access to any of the switch ports
F.HTTPS access to the management port
G.HTTPS access to any of the switch ports
Answer:A B F

3:A site needs a virtual server that will use an iRule to parse HTTPS traffic based on HTTP header values. Which two profile types must be associated with such a virtual server? (Choose two.)
A.TCP
B.HTTP
C.HTTPS
D.ServerSSL
Answer:A B

4:Which statement accurately describes the difference between two load-balancing modes specified as “member” and “node”?
A.There is no difference; the two terms are referenced for backward compatibility purposes.
B.When the load-balancing choice references “node”, priority group activation is unavailable.
C.Load-balancing options referencing “nodes” are available only when the pool members are defined for the “any” port.
D.When the load-balancing choice references “node”, the addresses’ parameters are used to make the load-balancing choice rather than the member’s parameters.
Answer:D

5:Which two statements describe differences between the active and standby systems? (Choose two.)
A.Monitors are performed only by the active system.
B.Fail-over triggers only cause changes on the active system.
C.Virtual server addresses are hosted only by the active system.
D.Configuration changes can only be made on the active system.
E.Floating self-IP addresses are hosted only by the active system.
Answer:C E

http://www.test4actual.com/F50-521.html

6:A site wishes to perform source address translation on packets from some clients but not others. The determination is not based on the client’s IP address, but on the virtual server their packets arrive on. What could accomplish this goal?
A.A SNAT for all addresses could be defined, and then disable the SNAT processing for select VLANs.
B.Some virtual servers could be associated with SNAT pools and others not associated with SNAT pools.
C.The decision to perform source address translation is always based on VLAN. Thus, the goal cannot be achieved.
D.The decision to perform source address translation is always based on a client’s address (or network). Thus, this goal cannot be achieved.
Answer:B

7:You have a pool of servers that need to be tested. All of the servers but one should be tested every 10 seconds, but one is slower and should only be tested every 20 seconds. How do you proceed?
A.It cannot be done. All monitors test every five seconds.
B.It can be done, but will require assigning monitors to each pool member.
C.It cannot be done. All of the members of a pool must be tested at the same frequency.
D.It can be done by assigning one monitor to the pool and a different monitor to the slower pool member.
Answer:D

8:Where is connection mirroring configured?
A.It an option within a TCP profile.
B.It is an optional feature of each pool.
C.It is not configured; it is default behavior.
D.It is an optional feature of each virtual server.
Answer:D

9:When using the setup utility to configure a redundant pair, you are asked to provide a “Failover Peer IP”. Which address is this?
A.an address of the other system in its management network
B.an address of the other system in a redundant pair configuration
C.an address on the current system used to listen for fail-over messages from the partner BIG-IP
D.an address on the current system used to initiate mirroring and network fail-over heartbeat messages
Answer:B

10:Assume a virtual server has a ServerSSL profile. What SSL certificates are required on the BIG-IP?
A.No SSL certificates are required on the BIG-IP.
B.The BIG-IP’s SSL certificates must only exist.
C.The BIG-IP’s SSL certificates must be issued from a certificate authority.
D.The BIG-IP’s SSL certificates must be created within the company hosting the BIG-IPs.
Answer:A

http://www.test4actual.com

http://www.test4actual.com/F50-521.html

http://www.test580.com